6.2.3.2 Command Procedure for DO-A Capable AIoT Device

The procedure defines the network triggered command procedure for a registered DO-A Capable AIoT Devices. The DO-A Capable AIoT Device shall have performed registration procedure according to clause 6.2.6 and the serving AIOTF has stored the corresponding AIoT Device context.

This procedure follows the Command Procedure defined in clause 6.2.3.1 with the following differences:

• Step 1.

The information about the target AIoT Device(s) is either one or multiple AIoT Device Permanent Identities, or Filtering Information, as described in clause 5.8.

Editor's note: The Filtering information used as information about the target AIoT Device needs coordination with SA WG3.

• Step 2.

As step 2 of the Inventory Procedure for DO-A Capable AIoT Device as specified in clause 6.2.2.2.

• Step 4.

The AIOTF does not need to retrieve information from the ADM if it is available in the stored AIoT Device context.

The AIOTF retrieves the AIoT Device Temporary Identifier(s) from the stored AIoT Device context(s), when AIoT Device Permanent Identifiers are provided in step 3.

The AIoT Identification Information to be provided to NG-RAN contains either Filtering Information as defined in clause 5.8, or an AIoT Device Temporary Identifier.

• Step 7.

Steps 7 to 11 of the Inventory Procedure for DO-A Capable AIoT Device as specified in clause 6.2.2.2 are performed.

• Steps 8 to 14.

As steps 8 to 14 in clause 6.2.3.1.